====================================
History DP/PN Coupler V2
(Order number: 700-158-3DP02)
====================================

V2.02.010  25.02.2022

- Web interface shows correct DP addresses and where they are set from
- Correctly show very long PN device names on the web interface
- Web interface contains download link for new firmware
- New checkbox appearance on the web interface
- DP inputs are zeroed after power up before PN side is connected

V2.02.002  02.07.2020

-  Supports new NAND flash type used.
-  Attention: Downgrade below FW V2.02.002 not supported if installed for compatibility reasons.

V2.00.122  16.12.2019:

-  Fixed sporadic occuring alarm "Peer MAUType mismatch" when port monitoring was enbled on automatically configured port.
-  Optimization for PROFINET stack library
-  Known Issue: Indicate the diagnosis "no peer detected" after plugging in ethernet cable might occur shortly and dissapear again once.  

V2.00.120  18.11.2019

-  Fixed LEDs flashing behavior indicating firmware update is performed.
-  Change: PROFIBUS connection is shut down when firmware update is performed.   
